E: marketing@hungseng.biz | T: +6019-371 6310 / +6012-5213037 / +6019-5143037

Services

Thorough & Stringent In-House Inspection Services


Apart from sourcing the right product for our clients, we are fully committed in assuring goods reaching to our customer’s doorstep are meeting the expected AQL (Acceptance Quality Level) requirements. Our main objectives of carrying out pre-shipment inspection is also to make sure no containers exported are reported rejected or complains when reaching to our customer’s hand.
To carry out a through and stringent inspection, a team of highly experienced is responsible for the inspection process. Our inspectors will verify the pre-shipment result done by the manufacturer by conducting the test as listed below:
Before conducting the test below, a random sampling is taken to obtain result on batch quality and highlight defects or inconsistencies. Standard criteria is based on ANSI/ASQ Z1.4 (ISO 2859-1)

Water-tight Test



Normally referred as water-leak test, this test is designed to detect any pinhole defects on the tested gloves. Things to look out for is water leakage on finger, palm, between finger and wrist area.



Air-tight Test



Most of the manufacturer on carry out either water-tight test or air-tight test to determine the pinhole level. Air-tight test is done to address the disadvantages of water-tight test which is to check for pinholes around finger-tip area.

Visual Inspection



This test is done in a bright lighted room to spot visual defects on the gloves. The most common defects are dirt, stains, lump, flow mark, and powder mark.

Gloves Thickness Inspection



Chosen randomly, gloves are to be texted for its thickness around cuff, palm and finger area to confirm that it meets the minimum specification.

Glove Length Inspection



As the minimum length requirement for ASTM standard is 230mm and EN standard is 240mm, it’s crucial to make sure that the gloves must meet its end user market’s requirements.

Glove Width Inspection



While carrying out the inspection, gloves are randomly inspected on the width to ensure there are no mix sizes.

Verify the Weight and Counting (pcs)



Often during production, gloves weight will fluctuate on the allowed tolerance of 0.2g per piece. In the event of gloves found doesn’t meet this requirement, the whole batch will be rejected. The weight fluctuation will also indirectly affect the average pieces of gloves when comes to counting.

Tensile Test



Before every shipment is cleared for export, a tensile report will be submitted to us for review. ASTM standards are more stringent than EN Standards therefore this physical property of gloves should not be overlooked.

Aging Test



To determine the durability and usability of the gloves after storage for a long period of time, aging oven is used to accelerate the aging process of the gloves. Set at 70 degree Celsius for 7 days, the condition mimics the gloves to be stored for a life span of 3 years.

OEM Packaging



When customers prefer products to be packed with their own packaging, we have an in-house packing centre to cater for the request.


Loading Supervision & Sealing of Containers



When a shipment is cleared to be exported, a HSG personnel will designated to supervise on the loading of the container up to sealing it with bullet and plastic seal.

This can be considered one of the crucial part of making sure goods loaded are of correct quantity.

Reportedly, many dishonest manufacturers tends to load less than the actual quantity to gain profit in this way.